APPLICATION OF FLOWING TESTS TO DETERMINE THE ZONES OF FILTRATION IN THE FORMATION TOWARDS THE HORIZONTAL BOREHOLE
Abstract
In this paper a new method of identification of the inflow profile (injectivity) in the horizontal hole based on the interpretation of pressure drawdown curves is presented. It is shown how the variation in the length of the zone of the influx to the horizontal hole after the acid treatment influences on the fluid flows in the formation and the pressure drawdown curves registered in the well.
About the Authors
M. L. Karnaukhov
Tyumen State Oil and Gas University
Russian Federation
Russian Federation
Doctor of Engineering, professor of the chair «Modeling and control of oil and gas recovery processes»
phone: 89222677181
D. I. Shustov
Tyumen State Oil and Gas University
Russian Federation
Russian Federation
postgraduate of the chair «Modeling and control of oil and gas recovery processes»
phone: 89220455500
T. A. Abramov
Tyumen State Oil and Gas University
Russian Federation
Russian Federation
postgraduate of the chair «Modeling and control of oil and gas recovery processes»
phone: 89123825399
D. E. Islamov
Tyumen State Oil and Gas University
Russian Federation
Russian Federation
postgraduate of the chair «Modeling and control of oil and gas recovery processes»
phone: 89829240348
Review
For citations:
Karnaukhov M.L., Shustov D.I., Abramov T.A., Islamov D.E. APPLICATION OF FLOWING TESTS TO DETERMINE THE ZONES OF FILTRATION IN THE FORMATION TOWARDS THE HORIZONTAL BOREHOLE. Oil and Gas Studies. 2014;(3):39-43. (In Russ.)
Views:
528
Email this article 
Post a Comment 