FEASIBILITY STUDY OF 3D GEOMECHANICAL MODEL CONSTRUCTION FOR SAND PRODUCTION CONTROL
https://doi.org/10.31660/0445-0108-2016-2-44-49
Abstract
In this article the expediency of using the coupled hydrodynamic and geomechanical model for prediction of sand production probability is considered. Additionally to the review of scientific papers a comparison is made of results obtained by several synthetic models in the course of the experiment. Based on the study results there was prepared a list of the fields characteristics the presence of which should indicate the necessity of using the coupled hydrodynamic geomechanical model for calculation of conditions that might lead to sand production.
About the Authors
I. I. Gurbanov
Tyumen State Oil and Gas University
Russian Federation
Russian Federation
A. A. Khakimov
Tyumen State Oil and Gas University
Russian Federation
Russian Federation
References
1. Morita, N. et al. Parametric Study of Sand Production Prediction: Analytical Approach, SPE Paper 16990, Dallas, 1987
2. Tronvoll, J. et al., The Effect of Oriented Perforations as a Sand-Control Method: A Field Case Study From the Varg Field, North Sea, SPE Paper 86470, Lafayette, 2004
3. Cook, C. et al., An Approach to Simulating the Effects of Water-Induced Compaction in a North Sea Reservoir, SPE Paper 71301, Dallas, 2001
Review
For citations:
Gurbanov I.I., Khakimov A.A. FEASIBILITY STUDY OF 3D GEOMECHANICAL MODEL CONSTRUCTION FOR SAND PRODUCTION CONTROL. Oil and Gas Studies. 2016;(2):44-49. (In Russ.) https://doi.org/10.31660/0445-0108-2016-2-44-49
Views:
485
Email this article 
Post a Comment 